Alerts
Last updated
Was this helpful?
Last updated
Was this helpful?
When you use this feature, you can set alerts that trigger anytime a sensor transmits a reading that is outside your desired range. The alert you created will appear on the list page of Alert V2 where you will see the following information.
Mode - In this column, you can check the mode of the alert i.e., whether the alert mode is auto or it is manually set by the user.
Status - This column will give you an update regarding the status of the alert i.e., whether the alert is active or inactive.
Entity - It is the entity of those sensors on which the alert conditions are applied.
Alert Description - It is the name of the alert which is given by the user.
Alert Status - As there can be a number of sensors in the alert. So at a time, some can be in normal form or some may be alerted. So this column helps in getting information about the alert status.
You can go to the search engine and search for an alert from those available in the current list. The search will apply to text in any of the following columns:
Mode
Status
Entity
Alert Description
Alert Status
You can edit the details of an alert by clicking on either the editing button or the Alert Description.
You can delete an alert by clicking on the delete button.
You can generate a duplicate copy of an alert by clicking on the duplicate button .
If there is a long list of alerts, then this list is converted into the number of pages. You can go to these pages by clicking on the respective button . You can go to the next page of alerts by clicking on the next button or can go to the previous page by clicking on the previous button . These buttons are available at the bottom right of each listing page of alerts.
You can maximize the alert page of the module TOOLBOX to full screen by clicking on the button which is next to the searching engine and can also leave the full screen by clicking again on the same button.
